Pavers are a beautiful addition to any house, but over time and unlike most structures around your home, they can move and shift. During the shifting, some of the pavers may dislodge. As such, they can become uneven, move around and eventually pop out of place. So how do you fix moving pavers? With a little time on your hands and the right materials, you can easily repair a paver patio.
How Do You Fix Moving Pavers
In this post, we’ll highlight a few tips on fixing moving pavers. The article will break down the process of replacing and resetting loose pavers and damaged pavers.
Inspection
Before unleashing your equipment and getting to work, start by inspecting the pavers. Look for loose, broken pavers, or even faded pavers. You also want to find uneven pavers. They could be simply tilted, higher or even lower than the other pavers. Then mark these pavers with a piece of chalk or another marker. You can also take this moment to kill weeds in between the pavers as well.
Remove the Pavers
Get rid of all the pavers you’ve marked off. When pavers are installed on your patio or driveway, for example, they’re seated in the sand. Sand can become nearly as hard as concrete once it dries. As such, you may need to send a concentrated stream of water using a hose along the edges of the pavers to be replaced, reseated or removed. After a couple of minutes, the sand will loosen up and you’ll have an easier time removing the pavers. You can use a small pry bar to remove some sand on the edges. Once you’re done, lift the paver and remove it. Repeat this process until you’ve removed all the marked pavers.
Replace the Pavers
A common issue with pavers is that the sand underneath can settle and shift, especially if you lay pavers over dirt. You want to add small amounts of sand. Then spread out the sand before tamping it down. You want it to form a strong and even base for the paver. Use a level to ensure everything is flat and even. Place the new paver in the space and compare its height in relation to the pavers around it so you can adjust the amount of sand as needed. A rubber mallet can come in handy to seat the paver in the sand by gently tapping it in place. Always make sure the pavers are even and lined up with the pavers around then repeat the process with all the pavers that will be replaced.
Sealing
To ensure the pavers stay in place, it’s important to seal them around the edges. Pour some sand over them and move it around with a push broom. The sand should fill the spaces between the pavers. Wet the sand a bit then repeat the process until all the gaps are completely full before sweeping away all the excess sand.
Bottom Line
With the tips mentioned, you can now answer the question: how do you fix moving pavers? With a little time and effort, you can have your paved patio or walkway back in good condition without much of a hassle. If you’re unable to do it on your own, seek the services of a professional paver installation company.